1. Why does CT feedback have an effect on harmonic compensation?
Active Harmonic Filter (AHF) may be insufficient in U.S. 480V/60Hz systems if TC polarity, ratio, position, or output is false.
The Active Harmonic Filter uses CT for the calculation and injection of the compensation flow. A suitable CT clamp for active harmonic filter systems must meet the input and measurement requirements of the controller. Check the CT first.
2. Where is AHF used in U.S. facilities?
2.1 HVAC manufacturing and application
Factory motors, pumps and HVAC VFDs generate harmonic currents. An active harmonic filter can attenuate these currents at a given connection point. For existing 480V distributors, the split-core current transformer for active harmonic filter projects can facilitate installation around available conductors.
2.2 Data center and water purification
In data centers and sewerage facilities, UPS devices and variable speed pumps require three-phase sensors and correct CT orientations.

3. How should engineers choose CT AHF clamps?
3.1 CT location and electrical direction
Correct current transformer placement for active harmonic filter systems depends on the source-side or load-side sensor construction of the AHF supplier. Follow your scheme. For active harmonic filter CT selection, the CT 400A/5A can be adapted to the 360A donor, provided it is approved by the controller supplier.
3.2 Output accuracy and harmony
A 5A secondary CT for active harmonic filter regulators cannot be replaced directly by an output voltage sensor. The 333mV CT for harmonic monitoring is only suitable when receiving devices use it.
At 60 Hz, the fifth harmonic is 300 Hz, the seventh is 420 Hz and 251500 Hz. The accuracy of class 0.5 on the base does not test either harmonic frequency or phase accuracy. Check the permeability, phase, load and polarity. Never open a conventional CT output current circuit.

4. Which HEYI CT clamps are suitable for AHF project?
4.1 HEYI DP Kerne Series Filter
HEYI offers options for a shared core with 5A output, including DP-23 (400A/5A, class 0.5, 5VA), DP-58 (600A/5A, class 0.5, 2.5VA) and DP-816 (1000A/5A, class 0.5, 5VA). They are just candidates. Verification of harmonic response and AHF compliance.
4.2 HEYI CCT-24 and example 480V
CCT-24 Hat Matrix Option 50A/333mV (6.66mV/A). Cannot be connected directly to input AHF controller 5A. With a hypothetical 480V/60Hz VFD emitter reaching a peak value of 360 A, the DP-23 400A/5A can be evaluated when verifying CT position, load, fit, and harmonic performance.

5. How can I confirm compliance and request a price?
Confirm before ordering AHF make/model, installation voltage, current band, CT ratio, output (5A, 1A or 333mV), cable length, installation space and required harmonic performance.An active harmonic filter requires a compatible sensor chain and not just a suitable current.
Need CT clamps for an electrical quality project in the United States? Send to HEYI ELECTRICAL your AHF model, CT requirements and quantity for technical verification and evaluation.
Compay: WENZHOU HEYI ELECTRICAL CO.,LTD
Brand: HEYI/ASCT
Contact: Bethy
E-mail: heyi@heyiele.com
Tel: 86-13968747975